Filter
Top Products
Initial settings
34
Switching over remote control’s command set
The remote control handset contains two command sets. This allows two receivers
to be operated independently in a room (not in conjunction with a twin receiver).
Note Switchover is possible for remote controls that have 24 and 26 keys.
For this purpose, programme one receiver on command set 1 and the second re-
ceiver on command set 2.
•
Switch on receiver 1. Switch off receiver 2 using the mains switch
on the
unit
.
⇒
Press the
key and keep it pressed.
⇒
Using the numeric keys
... enter “
901
“.
•
To adopt the code switch receiver 1 into standby using the
key, and then
switch the receiver off using the mains switch
on the unit
.
•
Set receiver 2 back into operation.
⇒
Press the
key and keep it pressed.
⇒
Using the numeric keys
... enter “
902
“.
•
To adopt the code switch receiver 2 into standby using the
key, and then
back into operation again. Set receiver 1 back into operation as well.
⇒
Press the
key and keep it pressed.
⇒
Using the numeric keys
... enter “
903
“.
Note
With the first two settings the remote control must be pointer towards the respec-
tive receiver which is switched on.
With the
key you can now switch between the two command sets A and B (tog-
gle function) and operate the two receivers in alternation.
On delivery command set 1 is always active.
Note
If you are using only one receiver and the active command set has been switched
over inadvertently due to maloperation rendering the receiver inoperable, the re-
mote control can be switched back to command set 1 without difficulty. The proce-
dure for this has already been described above.
Note
With remote control handsets that have 24 keys (remote controls of the 200-series
receivers from Kathrein) code numbers 001, 002 and 003 are to be entered in
place of codes 901, 902 and 903.