Filter
Top Products
Controls, displays and connections
4
Front panel controls and displays Rear panel controls and connections
1
Mains switch (with mains isolation)
2
LED display for TV (8-position, 7-segment display)
Displays programme slot and programme name as well as
menu settings.
3
Keys for selecting programmes
Step-by-step programme selection (upwards and down-
wards).
Switch from standby into operation as well as switchover
from TV to radio mode without using remote control.
1
Mains input socket
for 230 V/50 Hz.
2
DATA socket
a) Connection facility for the external infrared sensor URS
200.
b) Connection for the UFP 10 Copy-Programmer for read-in
and read-out of the programme data.
(function b is especially for service, for copying the
programme data).
3
VHF/UHF antenna input
(signal is looped through).
4
VHF/UHF antenna output
(TV signal modulator-output, Ch. 38 is preset).
5 Satellite IF, signal input and
output of LNB supply voltage.
6
Audio output, left and right channel
(Cinch sockets).
7
Audio digital output (SPDIF output) (Cinch socket)
8 Scart socket, TV connection
9 Scart socket, VCR connection
10
Scart socket, d
ecoder connection
Remote control handset keys
Function 1:
Command set changeover
Function 2:
To blank out the video signal (in setup mode) This
function is to be used if the picture no longer synchro-
nises on adjustment and the picture scrolls.
Starts a timer
Last-function. Allows you to switch back to the last pro-
gramme that was selected
Function 1:
Last-function. Allows you to switch back to the last
programme that was selected
Function 2:
Displays the info menu
(active only if after pressing the key
the
programme list is displayed.)
Function 1:
On/Off (Standby),
Attention: no mains isolation results!
Function 2:
Return from setup mode into normal operation
Function 1:
Calls up TV programme list (or radio programme list in
radio mode).
Function 2:
Calls up menu for "Programme slot sorting (insertion),
swapping and copying“
(with
press in succession)
Set timer, date and time
Function 1:
Selection of TV/SAT mode
Function 2:
Call up the menu for video settings
(with
press in succession)
Function 1:
Volume control
Function 2:
To alter settings data in setup mode
Function 1:
Step through the programmes either up or down
Function 2:
Selection of individual menu entries in setup mode
Function 1:
Stores the chosen settings
Function 2:
Primary key for calling up the separate settings menus
(e.g. video settings)
Function 1:
Switchover to radio mode
Function 2:
Calls up the menu for radio settings
(with
press in succession
Function 1:
Mutes the sound
Function 2:
Calls up the menu for audio settings
(with
press in succession)
to
Stereo/Mono- (2 channel) changeover
Numeric keys 0 - 9 for programme selection and fre-
quency entries