Filter
Top Products
Operation
10
Operation
Programme selection
The receiver is factory pre-programmed with most of the common
satellites. In order to be able to receive properly, of course, you should
have aligned the antenna onto at least one of these satellites.
Press SEL in order to call up the list of the pre-programmed satellites.
Select a satellite, and press OK. The receiver now shows all the
programmes transmitted over this satellite.
There is no printed programme list included in the scope of delivery.
Select the desired programme using the / keys, and press OK.
Note: Alternatively, you can call up the programme list of a satellite by
pressing OK immediately.
To choose a programme, enter its position using the number keys on
the remote control.
Press TV/R to change from the TV programme list to the radio
programme list, press FAV to call up a favourite list.
(4 lists).
Swap through these lists using either the Quality/P key, the Recall/P+
key or the /keys. Press EXIT so that the lists disappear.