Filter
Top Products
Installation menu
23
Searching for a new programme via a transponder search
1. Press 'Menu' on your remote control.
2. Select menu item 'Installation', confirm with 'OK'.
3. Then select menu item 'Search', confirm with 'OK'.
4. Now select the desired satellite using the 'left-right' keys.
5. Select 'frequency', and press 'OK'.
6. Now press the blue key 'Add'.
7. Now, the frequency, polarity and symbol rate must be entered.
8. Store your settings by pressing the green key.
9. Press 'OK' to confirm.
10. Switch menu item 'Search network' to 'Off'.
11. Press the green key ('TP') to start the transponder search. Again,
confirm with 'OK'.
12. Now the transponder is searched, and the programmes are added
on the end of the programme list.
13. Press 'Exit' to exit the menu again.
3) Search mode
Selecting the type of search: Searching for any programme or
only FTA (uncoded) programmes - if you search for any
programme, all programmes, inclusive of the encoded ones,
will be stored. Otherwise, merely the FTA programmes will be
stored.