Filter
Top Products
Audio-Video Receiver KRF-X9992D 73
Troubleshooting
Sound
• The individual speaker levels are set properly. See Chapter
Two of the Connections and Setup Guide.
• The CD2/Tape2 monitor input has not been selected. (If it
has, the CD2/Tape2 monitor indicator on the receiver’s front
panel will be lit). See “What’s on the Front Panel of Your
Kenwood Audio - Video Receiver?” on page␣ 2 of this manual.
• The correct speakers have been activated. See “Turning the
Speakers On” on page␣ 10 of this manual.
• The correct listen mode has been selected. See “What Are
Listen Modes?” on page␣ 16 of this manual.
I can’t hear sound from my surround or center speakers
Check that:
• The proper surround play mode (Dolby 3 Stereo, Dolby Pro
Logic, DSP, MPEG or Dolby Digital) has been selected. See
“What are Listen Modes?” on page␣ 16 of this manual.
• All of the speaker wires are connected tightly. See Chapter
One of the Connections and Setup Guide.
I can hear sound only from the center speaker when Dolby
Pro Logic or Dolby 3 Stereo is selected
Check that the program (e.g., TV show, radio station, VCR tape)
is in stereo. Programs in mono play only through the center
speaker when the receiver is in the Dolby Pro Logic listen mode.
Sound from one (or more) of my devices is abnormally
loud or soft
Adjust the analog input level for that device:
1. Select the icon for the device. For CD1, Video2, Video3, and
Video4, also select the Input Analog icon.