Filter
Top Products
23
Chapter One : Connecting Your Devices Audio-Video Receiver KRF-X9992D
Connections
Connecting Your Secondary CD Player or Tape Deck, continued
Do not plug in the receiver to AC power until you
have connected all your devices.
This section focuses on the connections from your
CD player or tape deck to the KRF-X9992D. Please
refer to your CD player or tape deck’s instructions
for more detail about its connection jacks and
capabilities.
Each set of instructions in this section shows one of
several possible variations on connecting your CD
player or tape deck. For further assistance on
optional configurations, contact the store where you
purchased your CD player or tape deck.
Do not connect a system control cable from any
unit connected via the CD2/TAPE2 MONITOR jacks.
To Connect a Secondary CD Player:
1. Connect the audio cables from the CD player’s
audio jacks to the receiver’s CD2/TAPE 2 MONI-
TOR PLAY IN jack set as shown to the left.
Do not connect the system control cable from
the second CD player, even if it supports system
control.
2. Go to “Noting Your Devices” on page␣ 3 and note
which jacks you used to connect your CD player.
In addition, note the brand name and model
number of the CD player.
If you connect a second tape deck, you cannot
connect a second CD player.
To Connect a Secondary Tape Deck:
1. Connect the audio cable from the tape deck’s
Play OUT jacks to the receiver’s CD2/TAPE 2
MONITOR PLAY IN jacks.
2. Connect the audio cable from the tape deck’s Rec
IN jacks to the receiver’s CD2/TAPE 2 MONITOR
REC OUT jacks.
Do not connect the system control cable from
the second tape deck, even if it supports system
control.
3. Go to “Noting Your Devices” on page␣ 3 and note
which jacks you used to connect your tape deck.
In addition, note the brand name and model
number of the tape deck.
If you connect a second CD player, you cannot
connect a second tape deck.