Filter
Top Products
HELIX DN9340E/DN9344E Remote Control Software
User Guide
30 of 65
6 Select the IP address of the HELIX
DN9340E/DN9344E unit you wish to connect to
this port, for example, “192.168.1.22”.
7 Make sure Echo is set to Generic Echo Off.
8 Click OK to accept port change, or Cancel to decline.
9 Assign port to device by
selecting device in List of Devices
and selecting port in the
available ports appropriate to
device in drop down list
(right-hand side), for example,
“Unit 1”.
The name of the assigned port
will appear under the Assigned
Port column (highlighted in
yellow opposite).
10 Click OK.
Your system should now be ready for online operation, as described in Section 7.6. Successful
HELIX RCS/unit communication is indicated on the units by the yellow NETWORK LED illuminating.