Filter
Top Products
HELIX DN9340E/DN9344E Remote Control Software
User Guide
51 of 65
To remotely program equalisation settings in another PC Memory location
1 Select a memory location from the Current PC Memory
drop down list in the upper memory tab. If you
are currently online, you will be warned that
switching memory will force the unit offline and then
asked to confirm the action.
2 Click OK to continue. The frequency response will be
updated with the settings held in the selected PC
memory.
3 Shape the frequency response of the new memory
location, as required, using the various Equalisation
tabs and working on or offline as appropriate.
Notes
If you go online and choose to Set All initial values from the PC - The settings
of the PC memory will be transferred to the active ‘scratchpad’ at the slave Unit but
they do not overwrite the stored memory settings. The memory location on the
graphic display refers to the last memory recalled to the scratchpad. Hence, you can
program PC memories on the scratchpad without destroying stored Unit memories.
Memories are only overwritten by a Store or Write All command.
If you go online and choose to Get All initial values form the Unit - The active
settings of the Unit will overwrite the settings in the current PC memory at the AddIn
Device.
To name a PC memory for reference purposes
1 Type in a name, maximum 20 characters, in the Memory Name field. Note that certain
symbols are not allowed, for example, % and £. The name will be appended to the number
in Current PC Memory field and will be downloaded to the unit under the Store command.
When a memory is recalled at the Unit to the active ‘scratchpad’, the name appears in the Unit’s
alphanumeric display.
To store the Current PC memory to a User memory at the HELIX Unit
1 Set the HELIX AddIn online.
2 In the lower Memory tab’s middle panel, select the User Memory in which you wish to store
the settings using the respective drop down list.
3 Click on Store User Memory. You are warned that the current memory will be overwritten, and
asked to confirm the action.
4 Click OK to continue or Cancel to abort.
Note
Settings cannot be sent to the unit Preset memories on an individual basis. To store a Preset
memory you must use the write all command - this downloads each PC memory to the
equivalently numbered Unit Memory, thus providing an extra safeguard against accidentally
overwriting essential settings.