51
ENG
ENGLISH
CUSTOMIZING SETTINGS
Picture ID Settings
Picture ID is used to change the settings of a
specic display using a single IR receiver for
multi-vision. Communication is possible between
a monitor with an IR receiver and other monitors
using RS232C cables. Each monitor is identied
by a Set ID. If you assign the Picture ID using
the remote control, only displays with the same
Picture ID and Set ID can be controlled remotely.
2 Press the ON (Red) button on the remote con-
trol to assign the PICTURE ID.
1 Assign the Set ID to the installed monitors as
shown below:
3 If you press the left/right buttons or the red ON
button for PICTURE ID repeatedly, the Picture
ID toggles between OFF and 1 to 4. Assign the
Set ID as you like.
y
A set with a different Set ID than the Picture
ID cannot be controlled by IR signals.
y
Please refer to the Installation Manual for
more information on the assigning Total Set
ID.
NOTE
Picture ID
Close
◄ Off ►
2X2 Multi-Vision (Total Set ID: 4)
Set IDs are assigned as shown in the picture.
AUDIO
(RGB/DVI)
REMOTE
CONTROL IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
IR Receiver
RS232C cable
Picture ID
Close
Off
y
If Picture ID is set to 2, the upper right
monitor, that has a Set ID of 2, can be
controlled by IR signals.
y
If you press the green OFF button for
PICTURE ID, the Picture IDs for all monitors
are turned off. If you then press any button
on the remote control, all monitors can be
controlled by IR signals regardless of Set ID.
y
The Picture ID function may not work while
MY MEDIA is operating.