Filter
Top Products
30
3-5. TV Connection - HD Monitor with HDCP (DVI-HDTV type)
TV Viewing
1.
Connect the “OUT TO TV” jack on the DIRECTV
®
HD Receiver to the “ANT IN” jack on your TV using a coaxial
RF cable.
2.
Connect the “DVI-HDTV OUT” jack on the DIRECTV HD Receiver to the “DVI-HDTV IN” jack of your TV using
DVI-HDTV type connector. (The “TYPE” switch must be set toward the “RGB/DVI-HDTV” jacks.)
3.
Connect the L/R “AUDIO OUT” jacks on the DIRECTV HD Receiver to the L/R “AUDIO IN” jacks on your TV using
RCA-type cables.
Note : For the best access to high-definition programming at the highest available resolution broadcast
by DIRECTV, connect the DVI-HDTV output to the corresponding DVI-HDTV input that supports high-band-
width Digital Content Protection (HDCP) technology on a High-Definition Television (HDTV) or HDTV moni-
tor. Please check your HDTV or HDTV Monitor user manual or contact the television manufacturer to find
out if your HDTV or HDTV Monitor supports HDCP.
4.
Select Antenna In or DVI-HDTV In, source on your TV. (Refer to TV user's manual.)
(1080i/720p/480p)(1080i/720p/480p)
RGB OUT
DATA PORT
DVI-HDTV OUT
SATELLITE
IN
TYPE
CABLE IN
ANT IN
OUT TO TV
Y
COMPONENT OUT
(1080ii/720p/480p/480ii)
Pr
1
L2
R2R1
L1
2
AUDIO OUT
Pb
OPTICAL
DIGITAL
AUDIO
OUT
S VIDEO
OUT
VCR
CONTROL
RF
REMOTE
(1080ii/720p/480p/480ii)
PHONE
JACK
VIDEO OUT
HD-Ready TV
ANT.IN L R
Phone wall jack
LNB
Sat B
LNB
Sat C
LNB
Sat A
Dish
5x4 Multi-switch
Output
Antenna
Cable TV
wall jack
DVI-HDTV IN