Filter
Top Products
83
8-10. Setting Default Signal Out
Output Channel
If you use the OUT TO TV jack, select channel 3 or 4 to send RF signal from your DIRECTV
®
HD Receiver to your TV. Your TV must be tuned to the selected channel to display the pic-
ture.
Loop Through
A signal from CABLE IN or ANT IN jacks is passed through to the OUT TO TV jack when
your HD receiver is in the standby (power off) mode.
To set Out to TV settings of the DIRECTV HD Receiver:
1.
Press the
MENU
button on the Remote Control to display the on-screen menu.
2.
Scroll down using “
E
” on the remote control.
3.
Select the
Setup
menu by pressing “”.
4.
Scroll down to Out to TV using “
E
”.
5.
Move the highlight to the right with “
G
”.
6.
Select your output channel to Channel 3 or Channel 4 with “
FG
”.
Select your default signal source to Antenna or Cable with “
FG
”.
7.
Press the MENU button to return to the previous menu or press the EXIT button on the
remote control to return to TV viewing.
8. CUSTOMIZATION