Filter
Top Products
Connections
ips
Depending on your TV and other equipment you wish
to connect, there are various ways you could connect
the Recorder Combi Receiver. Use only one of the
connections described below.
Please refer to the manuals of your TV, VCR, Stereo
System or other devices as necessary to make the
best connections.
Caution
Make sure the Recorder Combi Receiver is connect-
ed directly to the TV. Tune the TV to the correct
video input channel.
Do not connect the Recorder Combi Receiver’s
AUDIO OUT jack to the phono in jack (record deck)
of your audio system.
Do not connect your Recorder Combi Receiver via
your VCR. The DVD image could be distorted by the
copy protection system.
Connecting Antenna/Cable TV to
Recorder Combi Receiver
11
Disconnect the antenna leads from the rear of the
TV.
22
Identify the type of cable from your antenna. If it is
a round cable as illustrated, it is a 75 ohm coaxial
antenna cable. This cable will connect directly to
the jack marked ANT.IN on your Recorder Combi
Receiver.
ip
If your antenna lead wire is a flat type antenna cable,
connect it to an Antenna Adapter (300-ohm to 75-ohm)
(not supplied) and slip the Adapter onto the ANT.IN
jack. The Adapter does not screw on to the Recorder
Combi Receiver, it just slips over the jack.
Cable Service Without Cable Box
If your cable wire is connected to your TV without a converter
or descrambler box, unscrew the wire from your TV and attach
it to the ANT.IN jack on the Recorder Combi Receiver. Use the
supplied round coaxial cable to connect between the Recorder
Combi Receiver’s RF.OUT jack and the 75 ohm antenna input
jack on the TV. With this connection, you can receive all mid-
band, super band, and hyperband channels. (All cable chan-
nels.)
Cable Service With Cable Box
If a converter is required in your cable system, follow the
instruction below:
The cable hookup permits both TV and Recorder Combi
Receiver operation.
To view or record a CATV channel
1
Tune the TV to the correct video input channel.
2 Set the Recorder Combi Receiver channel selector to the
output channel of the Cable Converter box using TRK/
PRESET(-/+) (v / V) or number (0-9) of your Recorder
Combi Receiver. (Example: CH3)
3 Select the channel to view at the Cable Converter Box.
ote
If you are using a cable box to tune channels, it is not neces-
sary to do Auto Channel Set as indicated on page 26.
16
DVD/VCR
OUT
DVD/VCR
OUT
Cable TV
Wall Jack
Back Panel of
Typical Cable Box