Filter
Top Products
REFERENCE
71
Troubleshooting
Check the following guide for the possible cause of a problem before contacting service.
Symptom
No power.
No picture.
No sound.
Playback picture is poor.
Recorder Combi Receiver
does not start playback.
Picture from external input
is distorted
Some channels are
skipped over when using
CH (v / V)
Picture or sound of
broadcasting channel is
weak or missing.
Camcorder image not
shown.
Camcorder image via A/V
input or DV IN to Recorder
Combi Receiver is not
shown on TV screen.
Can’t play disc recorded
on this Recorder Combi
Receiver on another DVD
player.
Cause
The power cord is disconnected.
The TV is not set to receive Recorder Combi
Receiver signal output.
The video cable is not connected securely.
The TV power is turned off.
The equipment connected with the audio
cable is not set to receive Recorder Combi
Receiver signal output.
The audio cables are not connected securely.
The power of the equipment connected with
the audio cable is turned off.
The audio connecting cord is damaged.
The disc is dirty.
Tape heads are dirty.
Tape is a rental or was recorded on another
VCR.
No disc is inserted.
No tape is inserted.
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the guide.
The disc is dirty.
The Movie Rating level is set.
The video signal from the external compo-
nent is copy-protected.
The skipped channels were deleted with the
CH. Add/Del feature.
Antenna or cables are loose.
Wrong Tuning Band is selected in the
Recorder Combi Receiver Setup menu.
Camcorder is off.
Recorder Combi Receiver’s source is not set
to AV1, AV2 or DV IN.
The disc was recorded in Video mode.
Some players will not play even a finalized
disc recorded in Video mode.
The disc was recorded in VR mode.
Discs recorded with copy-once material can-
not be played on other players.
Solution
Plug the power cord into the wall outlet
securely.
Select the appropriate video input on the TV
so the picture from the Recorder Combi
Receiver appears on the TV screen.
Connect the video cable securely.
Turn on the TV.
Select the correct input mode on the audio
receiver so you can listen to the sound from
the Recorder Combi Receiver.
Connect the audio cable securely.
Turn on the equipment connected with the
audio cable.
Replace it with a new one.
Clean the disc.
Clean video heads.
Use v/V for manual tracking adjustment while
tape is playing.
Insert a disc or tape. (Check that the disc
indicator on the front panel display is lit.)
Insert a playable disc. (Check the disc type,
color system, and regional code.)
Place the disc with the playback side down.
Place the disc on the disc tray correctly inside
the guide.
Clean the disc.
Cancel the Movie Rating function or change
the rating level.
You cannot connect via the Recorder Combi
Receiver. Connect the component directly to
your TV.
Use the CH. Add/Del feature to restore chan-
nels. See “To Add or Erase Channels from
Memory” on page 27.
Tighten connections or replace cable.
Try “Tuning Band Select” options; see page
26 for details.
Turn camcorder on and operate
properly.
Use INPUT to select AV input channel (AV1,
AV2 or DV IN).
Finalize the disc; see page 33.
No solution.
The other player must be RW compatible in
order to play it.
No solution.