Linksys DMRW1000 Universal Remote User Manual


 
Setting Up Your Controller
6
Controller/Wireless-N Touchscreen Remote
Wireless Home Audio
Setting Up Your Controller
Setup with LELA
The Wireless Home Audio Installer will guide you through
the setup of your Linksys by Cisco Wireless Home Audio
devices. Below is an overview of the steps required to get
up and running.
Install EasyLink Advisor
Install Cisco Media Center software for your computer
Configure your Wireless Home Audio Devices
Create your Cisco account and register for music
services
To begin, insert the CD into your CD-ROM drive. 1.
Click the 2. Start Setup button and follow the on-screen
prompts to configure your Wireless Home Audio
devices.
Start Setup
Setup without LELA
The Controller is an optional accessory that will enhance
your Wireless Home Audio experience. It can be installed
into an existing Wireless Home Audio system without the
use of LELA.
NOTE: The installation process is simplified with
the use of the LELA CD-ROM and it is necessary
to use LELA to setup your Internet services.
The following instructions will guide you through the
necessary steps to get up and running with your existing
Wireless Home Audio setup.
Installing the Battery
The Controller comes with a battery that needs to be
installed and charged. You can use the Controller as the
battery is being charged.
To install the battery, perform the following steps:
Open the battery compartment.3.
Align the battery so that the notches line up with the 4.
grooves on the Controller. The plus and minus symbol
should align to the connectors on the Controller.
Slide the battery towards the battery connectors until 5.
the battery is connected.
Plus and MinusNotches
NOTE: The battery connectors on the Controller
should line up with the + and - symbols on the
battery.