Filter
Top Products
11
the ”Satellite installation” menu the
antenna switch corresponding to your satellite
installation.
•2 satellites on 22 kHz switch
•2 satellites on sound burst switch
•4 satellites on DiSEqC switch
• Common satellite system
Note
With “Common satellite system” (multi
link), no LNC power supply voltage is supplied
by the “SAT” socket.
• In the “Satellites on switch” menu,
select, for example, Astra for “Sat. 1” and
Hotbird (13° east) for “Sat. 2“, etc.
• In the “LNC frequency(ies)” menu, set
the corresponding oscillator frequency for
each LNC.
H) In the “Automatic channel search”
menu an overview is given of the settings
made to this point.
Select the line “Change settings” if you
want to correct the settings.
After you have confirmed with OK, the “TV
Location” menu is displayed again, etc.
I) If everything has been set correctly, start
programming by selecting “Perform
search” and confirm with the
OK button.
Once the channel search and save is
complete, the channel preview is displayed.
This can be removed using the END button.
First installation
➝
Start automatic programming:
After you have answered all the questions for
automatic programming, the selected settings
are displayed.
To search for and save channels.
J) Select the ”Perform search ” line.
K) Press the OK key to start automatic
programming.
The television searches for, saves and sorts
all TV programmes that can be received on
your antenna installation, and then displays
an overview of the programmes.
L) Now press the OK key to start programming
radio programmes.
The radio programmes are displayed in a
programme list.
Press the END button to close the programme
list and return to television operation.
Programming other satellites …
Continued from page 9, operating step E).
For the following settings, you will need the
corresponding information on the parameters
of the channels transmitted by the satellite.
– Select the line “Other”.
– Confirm with OK.
– Indicate whether your aerial system can
also receive high band.
Note
Satellites can transmit channels in the low
band and the high band.
– Enter the LNC oscillator frequency.
– In the “Video parameters for Sat.”
menu, enter:
– the “Standard” (transmission standard)
If you select “Automatic”, then a search will
be made for broadcasting stations with the
PAL, SECAM and NTSC standards. You can
also search for a broadcasting station with
a specific standard, e.g. SECAM.
– the “Amplitude”; normally “Amplitude
Autom.” is selected. For encoded channels,
it may be necessary to set another
amplitude value, e.g. 4.
–“Baseband”; normally “Baseband off”
should be selected. Some Pay TV decoders
require the baseband signal for decoding
Pay TV channels; in this case, select
“Baseband on”.
–“Polarity”; satellites can transmit
channels with a negative or a positive
polarity. If the polarity is set incorrectly, a
negative image of the picture will be
displayed, or the picture will flicker.
–”Sound carrier for Sat.” menu
In this menu you can select a sound carrier
frequency using the left/right arrows on the
ring, or set a frequency in the range 5.50 to
9.10 MHz directly using the numeric keys.
LCD_SAT_31715022_GB 10.08.2004, 15:44 Uhr11