Filter
Top Products
System Setup Controls
28
SYSTEM MENU
The System Setup controls many aspects of
the functionality in the DVR, including the
Password, Time and Date, Network and PTZ
setup.
Use the
▲▼ arrows to navigate through the
settings, and the
◄► arrows to change the
values. Press the ENTER button to enter a
submenu, and press the MENU/EXIT button to
return to the previous menu.
HARD DISK SETUP SUBMENU
The Hard Disk Setup contains information
about the installed Hard Drive (Total Hard
Drive Space, and Space Used), and allows the
user to Set the Overwrite and Format the drive.
OVERWRITE – If the Overwrite option is set to
Yes, when the Hard Drive becomes full the
system will begin overwriting the older
information. If Overwrite is set to No, then the
DVR will stop recording when the Hard Drive
becomes full.
FORMAT HDD – Formatting the Hard Drive
erases all stored video data (firmware settings
are not erased). When you choose to Format
the drive, the system will prompt you for the
password before formatting (The default
password is [111111] ).
NOTE: Once the drive has been formatted, you
will no longer have access to the previously
recorded data, and there is no recovery.
PASSWORD CHANGE SUBMENU
The Password Change submenu allows the
user to change the system password.
Any combination of buttons on the front panel
of the DVR can be used in the new password.
Enter the new characters, and press the Enter
button to finish.
A Password Changed message will be shown
on screen when the password is successfully
changed in the system.