Filter
Top Products
067392-++2137438 45 ,-+/+.
75
Connecting Motion / Alarm Device - Appendix #5
Connecting Motion / Alarm Device - Appendix #5
Motion detection and Alarm controls are enabled through the Menu system on the DVR.
Additional motion sensor devices can be connected to the system (Motion Sensors, Door/
Window Sensors).
DVR
SENSOR
(Not Included)
1
2
A motion detection or sensor unit can
be used to send a signal to the DVR
to begin camera viewing on the
matching Video Channel (when
enabled in the MENU/ALARM SET
MODE)
• Example: A Window sensor unit
has been installed on Alarm
Block port #4. When this sensor
is activated, the camera on DIN
or BNC VIDEO port #4 will
become active (if enabled in the
MENU on the DVR)
For the corresponding Menu Pro-
gramming, refer to Page 26.
Installing a Sensor
1. Connect the GROUND Cable to the
GND port on the Alarm Block on the
DVR
2. Connect the SIGNAL Cable to a
numbered port (1-8)
To start ALARM RECORDING on a
DVR unit, refer to the manual for
your specific DVR product.