Filter
Top Products
21
Sensor Set
Sensor Set
1. SENSOR RECORD DURATION - Sets the length
of time for the recording once a sensor input has
been detected (i.e. If Motion is detected, the DVR
will start recording, and will continue recording for
10 seconds). Navigate to this option using the
buttons, and press the button to change the
option to one of the following settings: OFF / 10 /
20 / 30 / 40 / 50 and 60 seconds.
2. SENSOR1 - SENSOR4 - Sets the input type for
each sensor. Navigate to this option using the
buttons, and press the button to change the
option to one of the following settings: N/OPEN
(Normally Open) or N/CLOSE (Normally Closed).
This submenu allows you to change the settings for a separate sensor device (such as a
stand-alone Motion Sensor, or Door/Window Sensor). These sensors are installed on the ALARM
BLOCK (see page 41 for Alarm Block Configuration).
SENSOR
SENSOR RECORD DUR.
SENSOR1
SENSOR2
SENSOR3
SENSOR4
[ 10 SEC]
[ N/OPEN ]
[ N/OPEN ]
[ N/OPEN ]
[ N/OPEN ]
[]MOVE []SELECT []EXIT
Motion Set
1. MOTION RECORD DURATION - Sets the length
of time for the recording once motion detection has
been detected. Navigate to this option using the
buttons, and press the button to change
the option to one of the following settings: OFF /
10 / 20 / 30 / 40 / 50 and 60 seconds.
2. CHANNEL1 - CHANNEL4 - Sets the Channel to
ON/OFF for recording Motion. Navigate to this
option using the
buttons, and press the
button to change the option.
3. SENSITIVITY - Sets the sensitivity for Motion
Detection from 1 (low sensitivity) to 5 (high
sensitivity). Navigate to this option using the
buttons, and press the button to change the
option.
This submenu allows you to change the settings for cameras with integrated motion sensors.
MOTION
MOTION RECORD DUR.
CHANNEL1
CHANNEL2
CHANNEL3
CHANNEL4
SENSITIVITY
[ 10 SEC]
[ N]
[ Y ]
[ N ]
[ N ]
[ 3 ]
[]MOVE []SELECT []EXIT