Filter
Top Products
41
Connecting Alarm Device - Appendix #5
Connecting Alarm Device - Appendix #5
Alarm controls are enabled through the Menu system on the DVR. Additional alarm devices can
be connected to the system (Motion Sensors, Door/Window Sensors).
A motion detection or sensor unit can be used to send a signal to the DVR to begin camera
viewing on the matching Video Channel (when enabled in the MENU/ALARM SET MODE)
• Example: A Window sensor unit has been installed on Alarm Block port #1. When this sensor
is activated, ALL CAMERAS will become active (if enabled in the MENU on the DVR)
For the corresponding Menu Programming, refer to Page 26.
Installing a Sensor
1. Connect the GROUND Cable to the GND port on the Alarm Block
on the DVR
2. Connect the SIGNAL Cable to a numbered port (1-4)
DVR
1
2
SENSOR