Magnavox 26MV402X CRT Television User Manual


  Open as PDF
of 55
 
English
31
Network
Set up network connection settings in order to use Smart TV or
network upgrade function.
• The meanings of abbreviations are dened as below.
AP :WirelessLANAccessPoint
WPS :Wi-FiprotectedSetup
SSID :Wirelessnetworkname
• The key entry screen will appear when you select SSID,
WEP / WPA / WPA2 or Proxy address.
1 2 3 4 5 6 7 8 9 0
a b c d e f g h i j
k l m n o p q r s t
u v w x y z . - _
Clear Allclear a/A/@ Cancel OK
• Enter the key of the selected wireless network using ▲▼◄►,
then press OK.
Clear : Clear the entered number or word.
Allclear : Clear all the entered numbers or words.
a/A/@ : Switch between abc, ABC and @ ! ?
Cancel : Shows the cancellation display.
OK : Set the entered number or word.
1 Use ▲▼ to select Network, then press OK.
Picture Language English
Sound Channels Autoprogram
Features Preferences Location
Installation Network Network settings assi
Software Reset AV settings Start now
Networksettingsassistant
Before you proceed to Connectiontest or other settings in Network
section, set this selection to suit your preference.
2 Use ▲▼ to select Networksettingsassistant, then press OK.
Language Network settings assistant Start now
Channels Manual network settings Network selection
Preferences Connection test Start now
Network Setting status Information
Reset AV settings Reset network settings Start now
3 Press OK to select Startnow.
Wirelesssetting
Select to use a wireless LAN to connect to the Internet by wireless
connection.
4 Use ▲▼ to select Wireless, then press OK.
ThisTVcanbeconnectedtoyourhome
network.
Selectyourconnectiontype.
Wireless
Wired
Cancel
5 Use ▲▼ to select the desired setting, then press OK.
Simpleconnect
Select this setting if your router has a WPS
button. Start scanning for wireless networks on
the TV after pressing the WPS button on your
router. If connection test fails, try Simple connect
again.*
1
If it fails then refer to the router’s manual for
more details.
Scan
Search for wireless networks automatically
and select the SSID from the list.
Wirelessnetworksetting
➠
p.32
Manualentry
Set up the connection to the AP (e.g. wireless
router) manually by entering the SSID.
*1 WPS (Simple connect) cannot be used when the security protocol is set to
WEP. Change the Access Point’s security mode from WEP to WPA or WPA2
(recommended).
Wiredsetting
Select to use an Ethernet cable to connect to the Internet by wired
connection. Please purchase shielded Ethernet cables at your local store
and use them when you connect to network equipment.
4 Use ▲▼ to select Wired, then press OK.
• Connectiontest will start automatically.
➠
p.33
Manualnetworksettings
2 Use ▲▼ to select Manualnetworksettings, then press OK.
Network settings assistant Network selection Wireless
Manual network settings Wireless network setting Auto
Connection test IP configuration IP setting mode
Setting status
Proxy configuration Proxy setting
Reset network settings
Networkselection
3 Use ▲▼ to select Networkselection, then press OK.
4 Use ▲▼ to select the desired setting, then press OK.
Wired
If you connect to an Ethernet cable, select Wired
to connect to the Internet.
Wireless
If you have a router with WPS function, select
Wireless to connect to the Internet.
Continued on next page.
 previous next