Filter
Top Products
18
One Touch Recording
The one touch recording (OTR) function
allows you to program an immediate timed
recording 30 minutes to four hours long
without setting the timer. Before you
begin, make sure:
• Channels have been programmed.
• The desired recording speed (SP, LP,
SLP) has been selected with the (Tape)
SPEED button.
• There is a tape in the VCR (make sure
the tape's record tab is intact and the tape
is long enough to record the program(s).
• The VCR is in VCR position.
Starting an OTR
1
Use the CHANNEL (Up/Down) buttons or
Number buttons to select the channel you
want to record.
2
Press the REC(ord)/OTR button twice. The
screen below will appear.
TR 10:00) CH121
3
Press tee REC(ord)/OTR button until the
desired recording length (30 minutes to four
hours) is in the upper left comer of the
screen. Recording will begin immediately.
Stopping an OTR
To stop an OTR before recording is fin-
ished, press the STOP button or the
POWER button. To cancel the OTR but
continue recording, press the REC(ord)/
OTR button repeatedly until REC appears
on-screen.
o
Remote Control
2
Press the
REC(ord)/OTR
button three to ten
times to start an
OTR and select a
recording length.
O c===_ O
Use the CHANNEL
(Up/Down) button or
Number buttons to
select the channel
you want to record.
• To check the time remaining for an OTR after the OTR has been set, press
the STATUS button.
• To change the recording length while an OTR is in progress, press the
REC(ord)/OTR button until the desired length is displayed on-screen.
• If you begin an OTR when a recording is paused, the OTR will begin.
• You can not pause the recording (for example, during commercials), during
an OTR mode.
• If the preset time for a timer recording comes up during an OTR, the OTR
has priority.