Filter
Top Products
7
Turning on Your VCR
TV and VCR
CH3 CH4
1
Set the TV to channel
3 or 4, whichever
channel the CH3/CH4
switch on the back of
the TV is set to.
2
Press the POWER
button.
Press the Number 1
button for English or
the Number 2 button
for Spanish on-screen
displays.
Remote Control
00000
_o oo
Press the CHANNEL
(Up) button.
Press the MENU
button.
4t
• If you do not see any on-screen displays when you turn on the VCR, repeat
the steps under "Hoo_'ng Up Your VCR" on page six, then try again. If
you still do not see any on-screen displays, follow the steps under "'Channel
Memory" on page 28 and "Language Selection" on page 30.
• Toskip this feature andplay a tape immediately, insert a tape with its
record tab removed. Playback will start immediately. Or, to skip step 3,
press the MENU button. All on-screen displays will be in English. To skip
step 4, press the STOP button. Channels will not be programmed, and
TUNER NOT SET will appear on-screen.
• To change the language or program channels at a later time, follow the
steps on pages 28 and 30.
• Ifyou try to program channels when there is no antenna or cable connected
to the VCR, programming will appear to take place, but eventually NO TV
SIGNALS will appear on-screen. If this happens, connect an antenna or
cable to the VCR and try again.
• You cannotprogram channels ifa cable converter box is connected to a
VCR that is connected to a TV If you have this kind of connection, see
page 38for details.
•: Before turning on your VCR, make sure
• there are batteries in the remote control and
i the VCR and TV are connected (see pages
: five and six).
1
: Turn the TV on. Set it to the same channel
" as the CH3/CH4 switch on the back of the
: VCR.
: Press the VCR button, then the POWER
:" button. The VCR light will appear and the
• language select display shown below will
• appear.
: I 1 ENGUSH ON I
: [ MAKESELECTIONOR 1
: k_SH MENU"ro CONTINUEJ:
i Press the Number I button to select English
i on-screen displays or the Number 2 button
: to select Spanish on-screen displays.
i4
! Press the MENU button. The channel pro-
• gram display shown below will appear.
i Tovc. !
: THEN... l
PUSHCH UP KEY /
i OR..,
•
,,_,,.,_Yo_L,-PUSHs
Press the CHANNEL (Up) button, to begin
i automatic channel programming. The VCR
i will place all of the channels you receive
into its memory, so when you scan through
! channels using the CHANNEL (Up/Down)
- buttons, you'll only scan through channels
i that you receive. When channels are pro-
grammed, AUTO SET COMPLETED will
i appear on-screen briefly. Then the TV will
i go to the lowest channel programmed.