Filter
Top Products
33EN 33EN
Recording
Playback Editing
Introduction
Connections Basic Setup Function Setup VCR Functions
Others Español
SATELLITE LINK
8
Press [OK].
“To Standby Mode” is highlighted.
9
Press [OK] again.
Satellite Link
To Standby Mode
5:00PM DVD SP (2Hr)
Start Mode
DVD
VCR
In a second, the unit will be turned off
automatically as it goes into the satellite link
standby mode.
To cancel the satellite link function while in
the satellite link standby mode:
Press [TIMER SET] to turn on the unit.
To cancel the satellite link function while the
satellite link recording is in progress:
Press [STOP C] on the front panel to stop the
disc recording.
Press [STOP C/EJECT A] on the front panel to
stop the cassette tape recording.
Notes
• If the signal of external input breaks up over 5 seconds, satellite link function will be canceled.
• If you have not set the clock, “Clock Setting” menu will appear at step 3. Follow to step 3 in “Clock Setting” on
page 23.
• You cannot set the ending time for the satellite link timer recording on this unit.
• Recording picture will be distorted if the copy protection signal is being detected during satellite link timer
recording.
• You can record the satellite link by using S-video input jacks on the rear panel. Refer to page 15 for more
information.
• When a regular timer recording and the satellite link timer recording are overlapped, those recordings are
recorded as illustrated below.
• Press [TIMER] during the satellite link timer recording to check the satellite link timer recording in progress.
example 2
actual
recording
timer
recording
satellite link
example 3
actual
recording
timer
recording
satellite link
The rst 2 minutes (at the longest) will be cut o.
example 1
timer
recording
actual
recording
satellite link
The rst 2 minutes (at the longest) will be cut o.
E9E8BUD_ZV427MG9.indd 33E9E8BUD_ZV427MG9.indd 33 2008/03/27 13:31:492008/03/27 13:31:49