Filter
Top Products
40
CHAP. 6 Network Setup
Setting Screen
PTZ TYPE : If using PTZ device or camera, select the protocol your PTZ camera is using from the list of
preconfigured protocols.
Circular Monitoring Interval : This determines the speed at which the channels sequence, when the
SEQUENCE button is used from the main interface.
PTZ Baud Rate : Enter the Baud Rate of your PTZ camera.
Run in full screen mode : When checked, this will enable the program to re-adjust the interface to
completely fill your computer screen.
Set Path to Save Recorded Image : Determines the location and folder on your PC where the saved
video clips are stored. If you do not specify a valid location, then the
program will save all files in the default location of
C:\Program Files\DvrRemoteViewer4
Name(LABEL) : This just identifies your settings. The settings are automatically saved under this label
when you hit ‘OK’.
IP Address : Based on your network scenario and from where you’re accessing, enter the appropriate
IP address.
PORT : Enter the Port Number you assigned the DVR.
ID : Always enter ‘admin’
Password : This must match the password on the DVR. For simplicity, just use numbers.