Memorex MVBD2535GPH Blu-ray Player User Manual


  Open as PDF
of 194
 
45
TROUBLESHOOTINGGUIDE
Checkthefollowingbeforerequestingservice:
SYMPTOM
GENERAL
Nopower.
Poweron,butunitnotfunctioning
properly.
Nopicture.
Nosound.
Playbackpicturerolls.
Theplaybackpictureispoor.
TheSearchfeatureisnotworking.
Thepictureisnotfittingproperly.
Theremotecontrolisnotworking.
ThePreferencesmenucannot
beaccessed(itisdimmed)inthe
Setup menu.
POSSIBLESOLUTION
PlugintheACcordtoanACoutlet.
Unplugtheunitandwaitaboutoneto
twohourstoallowtheplayertodry.
Thisunitcannotplaydiscsotherthan
thoselistedonpage16.
PressthePowerbutton,thenunplug
thepowercord.Waitoneminuteand
thenplugtheunitbackin.
Cleandiscandinsertlabelside-up.
Thisisnormal;tryanotherfunction.
Connecttheequipmentaccordingto
theinstructionsinthismanual.
Selecttheappropriatevideoinput
mode,usuallyVIDEOorAV.
Connectthevideocablessecurely.
TurntheTVon.
Connecttheequipmentaccordingto
theinstructionsinthismanual.
Selecttheappropriateaudioinput
mode.
Connecttheaudiocablessecurely.
Turntheaudioreceiveron.
SetunittoNTSC.
Cleanthedisc.
Thisisnormalonsomediscs.
SelectthecorrectTVScreen(16:9
Wide,16:9Pillarbox,4:3Pan&Scan,4:3
Letterbox).
Installfreshbatteries.
Installbatteriesaccordingtothediagram.
Aimtheremoteatthesensor.
Operatewithin20ft.,orreducethelight
intheroom.
Removetheobstacle.
Removethediscfromthedisctray,as
therecannotbeadiscinsertedwhen
settingthepreferences.
POSSIBLECAUSE
ACcordunplugged.
Condensationhasformed.
Wrongtypeofdiscinserted.
Unitneedstobereset.
Thediscisdirtyorinsertedincorrectly.
Somefeaturesandfunctionsarenot
availableonalldiscs.
Theequipmentisnotconnectedproperly.
TheINPUToftheTVisnotsettoreceive
thediscsignaloutput.
Thevideocablesarenotsecurely
connected.
TheconnectedTVpowerisoff.
Theequipmentisnotconnectedproperly.
Theequipmentconnectedwiththeaudio
cableisnotsettoreceivethediscsignal
input.
Theaudiocablesarenotsecurely
connected.
Theconnectedreceiver’spowerisoff.
UnitisincorrectlysettoPAL.
Thediscisdirty.
Somediscshavesectionsthatdonot
allowsearching.
Wrongmenuoptionisselectedinthe
Setup menu.
Thebatteriesareweakordead.
Thebatteriesarenotinstalledproperly.
Theremoteisnotaimedatthesensor.
Distanceistoofarorthereistoomuch
lightintheroom.
Thereisanobstacleinthepathofthe
beam.
Thereisadiscinthedisctray.
 previous next