Filter
Top Products
Setting up the DVD player
60
To connect to other Meridian 500
Series equipment
● Connect one of the COMMS sockets on the back panel of the
DVD player to one of the COMMS sockets on another 500
Series unit, using the 500 comms lead provided with the 598
DVD Audio Player.
The sequence in which you connect the units is not important.
598 DVD Player 500 Series unit
COMMS COMMS
Then configure the units with the following automatic setup
procedure:
● Switch all the units to standby.
● Press Clear (remote).
Each unit will display:
Auto
Connecting to other Meridian equipment
One unit will then be designated
as the controller, and display:
Controller
This is the unit that will respond to the remote.
All the other units will be configured
as non-controllers, and display:
Not Con.
Your system is now set up and ready for use.
● If for any reason the automatic setup does not give the
configuration you want, restore the default operation by
selecting one of the standard types; see Choosing standard
settings, page 62.
Note: Do not, under any circumstances, connect any equipment
other than Meridian 500, 800, 600, or 200 Series to the socket
marked COMMS on the back of the DVD player.