Filter
Top Products
Configuring the DVD player
62
Choosing standard settings
The DVD player provides four standard settings, called Types,
which configure the 598 into the most commonly needed
configurations.
Choosing one of the four Types overrides any other
configuration you may have performed, and so can be used to
reset the configuration of the unit.
Types 1 and 2 are for use with multi-channel 96kHz surround
processors; choose Type 1 if you have a Meridian 568.2 or 861, or
Type 2 if you have a non-Meridian processor. Types 0 and 3 are
for use with surround processors without a multi-channel input;
choose Type 0 if you have a system that does not support 96kHz,
or Type 3 if you have a Meridian 96kHz surround processor.
The following table gives full details of each Type:
Type Main output Aux output
0 PCM, 48kHz Bitstream
1 PCM, 96kHz, multi-channel, MHR Bitstream, MHR
2 PCM, 96kHz, multi-channel Bitstream
3 Bitstream, 96kHz, MHR
Bitstream
All Types set the video output to S-video.
To restore the standard settings
● Switch the 598 to standby.
● Hold down Off (front panel).
After a short delay the display
will show:
Type,wait...
● Press [ or ] on the front panel to change the Type
number.
For example, if you select Type 1
the display shows:
Type 1
● Wait until the display shows:
Typing, wait
The display then shows:
Type 1
● Press Off to switch back to standby.
● Switch on again to use the 598 with the standard setting you
have selected.