Mitsubishi Electronics 154 Flat Panel Television User Manual


  Open as PDF
of 104
 
50 4. TV Menus
For assistance call 1(800) 332-2119
Sound Global
Settings in this menu apply to all inputs.
Analog Audio
Out
These settings affect audio from the AVR/SURROUND OUTPUT jacks.
Fixed Use with an analog A/V receiver. Control volume from the A/V receiver. The
volume of the audio output signal is fixed and is unaffected by the TV’s volume
control.
Variable Use with headphones. Adjust headphone volume using the TV’s volume controls.
When set to Variable, the audio output signal is adjustable from the TV’s volume
controls.
Rear Sends left and right rear audio to external speakers.
Use when supplementing the
TV’s speaker array with external rear speakers. See “External Rear Speakers,” page 41.
Subwoofer Select On to turn on audio to a connected subwoofer. Set to Off if no subwoofer is connected.
Center Channel On allows the TV’s speakers to complement your external sound system as a center channel. Set
to Off if not in use.
Sound Auto SP
265 Series. Performs auto calibration of the Sound Projector speaker array. See “Auto
Setup,” page 40.
Sound SoundPro
Lets you set up the Sound Projector speaker array manually. See page 38.
Sound, continued
Sound Mode Stereo No special audio effects from the TV speakers
Surround Modifies audio from the TV speakers.
• Formonaural(non-stereo)programs,createsasimulatedstereoeffect.
• Forstereoprograms,createsasimulatedsurround sound effect.
• TheTV’sspeakerarrayplayssurroundsoundifavailable.
Music Optimizes the TV’s speaker array for music listening.
Night Focuses the TV’s speaker array to a single point to limit sound heard by others
outside the room. Press
ENTER
to adjust the focal point (Night Angle).
Level Sound On, Off Reduces differences in sound volume between programming segments, such as the
difference between regular broadcast programs and commercial segments.
Listen To
(applies only
to analog
channels from
the
ANT
input)
Stereo The TV plays stereo broadcasts in stereo and mono broadcasts in mono. The word
Stereo is displayed when you tune to a channel broadcasting in stereo.
Mono Reduces background noise. Use when receiving a weak stereo audio signal. All
audio is played as mono.
SAP
(Second Audio
Program)
Selects an additional monaural sound track not audible during normal TV viewing.
The SAP signal might be related to the program (such as a sound track in a foreign
language), or it might be unrelated (such as a weather report). If an SAP signal is
broadcast, the letters SAP are displayed when you tune to the channel.
 previous next