Filter
Top Products
7
For assistance call 1(800) 332-2119
Wall-Mounting
To order a wall-mount kit, please contact Peer-
less Industries, Inc. at (800) 473-3753 or visit
www.peerlessmounts.com. Order wall-mount kit model
ST650.
To order a wall-mount kit from Mitsubishi Digital Elec-
tronics America, Inc., please visit www.mitsuparts.com
or call (800) 553-7278.
Complete installation instructions are included with the kit.
Stand Removal Prior to Wall-Mounting
Disconnect the TV’s AC power cord from the AC
1.
power outlet.
Spread the protective sheet that was wrapped
2.
around the TV on a flat, even surface, such as a
sturdy table. The protective sheet will help prevent
damage to the display.
IMPORTANT: To avoid damaging the screen,
make sure there are no foreign objects under or
on top of the protective sheet.
Position one person on each side of the TV (left and
3.
right sides). Have each person firmly grasp their side
of the TV and gently place it face down on the pro-
tective sheet with the display stand hanging over the
edge of the table. See the illustration to the right.
Use a magnetic philips screwdriver to remove the
4.
stand screws from the recessed holes (see illustra-
tion to right). Note: A regular screwdriver can be
used with a separate magnetic pick-up tool.
While one person holds the TV with both hands,
5.
have the other person grasp the stand (see illustra-
tion to the right) and remove the stand by pulling it
away from the TV in the direction of the large arrow
shown in both illustrations.
5BCMF
1SPUFDUJWF
TIFFU
57
4UBOE
CAUTION
At least TWO PEOPLE are needed to safely remove the stand. Have one person hold the TV while the other person
removes the stand. Failure to follow these recommendations may result in personal injury and damage to the product.
Note
55-inch TV: • Remove the factory-installed stand prior to wall-mounting.
40- or 46-inch TV:• If you installed the stand for table-top use, follow these instructions to remove it prior
to wall-mounting the TV.
55-inch TVs
(6 screws)
40- and 46-inch TVs
(4 screws)
Protective
Sheet
Pull stand
to remove.