Filter
Top Products
12 1. Basic Setup and Operation
Selecting an Input to Watch
Press
1.
ACTIVITY
.
Press
2.
and to highlight an input.
Press
3.
ENTER
to switch to the input.
Watching Broadcast TV
TV Connected to an Antenna, Direct Cable, Cable
Box, Set-Top Box, or Satellite Receiver
Select an input to watch from the
1.
Activity menu’s
Watch TV group.
Note: For more about the Activity menu, see page 21.
Activity menu, antenna input selected
Tune to a channel on the
2. ANT
input using any of
these methods.
Enter the channel number using the number •
keys on the remote control and press
ENTER
.
For a two-part digital channel, such as 3-1,
press
3
—
CANCEL
1
to enter a dash (separator).
Press •
CHANNEL UP /CHANNEL DN
(
+
/
–
) to change
channels one channel at a time.
Press •
(LAST)
to switch back to the previ-
ously tuned channel.
Antenna or Direct Cable Only.• Press
GUIDE
to
display ChannelView channel listings, highlight
a channel number, and press
ENTER
to tune.
Watching DVDs or Videos
TV Connected to a DVD Player, DVR, or VCR
Press
ACTIVITY
and select a movie source from the
Activity menu. If you named devices during Auto Input
Sensing, select the input from the Watch Movie group.
Activity menu, DVD input selected
Basic TV Operation
TV Tips
Turning the TV On or Off
Point the remote control at the front of the TV •
and press the
POWER
button.
Press the •
POWER
button on the TV control
panel.
If You Turn Off the TV by Mistake
Press •
POWER
again, within about 60 seconds,
to have the TV come back on immediately.
If the status indicator starts rapidly blinking •
green (about 60 seconds after you shut off
power), wait a few moments for the status indi-
cator to stop blinking and press
POWER
to turn
the TV on again.
Controlling Sound Volume
Press •
VOLUME
UP/VOLUME DN
to adjust the sound
level.
See also • “Controlling A/V Receiver Sound
Volume” on page 22.