Filter
Top Products
14
Adding and Deleting Channels
If necessary, you can manually add or delete channels after you
have completed the automatic channel memorizing.
1 Make sure that video mute is ON. See page 39.
2 Set the VCR’s input to tuner. To do this, press INPUT on the
remote control until a channel number appears on the screen.
3 Press MENU on the remote control. VCR Main Menu appears.
4 Press the ADJUST buttons on the remote control to select First
Time Set-Up. Press ENTER.
5 You will see the First Time Set-Up menu. Press the ADJUST
buttons to select Add/delete channels. Press ENTER.
IMPORTANT
If you are playing back a tape or receiving a video signal
from an external input, then Not available will flash on-
screen. To correct this, stop the tape or turn off the menus
and switch the VCR’s input to tuner.
6 You will see the screen for adding or deleting channels. Use
the ADJUST buttons to select the channel that you want to add
or delete. Press ENTER to add the channel; press CANCEL to
delete it.
7 When you are finished adding or deleting channels, press
MENU three times to exit the menus.
IMPORTANT
If you use automatic memorizing again, you will lose all of the
manual changes you made. All of the channels you deleted will
be added; all of the channels you added will be deleted.
Selecting a Channel
Now that you have memorized channels, and added or deleted
some, you will want to be able to select channels. If you have not
yet memorized channels, see page 13, Memorizing Channels
Automatically.
Antenna/Cable selections Your VCR can receive
indoor/outdoor antenna VHF/UHF channels 2–69
cable antenna cable channels 1–125
If you try to select a channel number that the VCR cannot receive,
the VCR will not change channels.
selecting channels sequentially
Press CHANNEL on the remote control or on the VCR front panel.
This will cycle through the channels in sequential numerical order.
selecting channels directly
Use the number buttons on the remote control. For example, to
choose channel 23, press 2-3.
To select a single digit channel, such as channel 5; press 5. You
can also press 5, then press ENTER.
Setting Up Your VCR
«Add/delete channels
Channel 39
Not in memory
∫πMENU to go back
∂ ππADJUST to select
≤¥≥πENTER to add
† ∑ ππADJUST to select
≠πππππCANCEL to delete
ƒFirst Time Set-Up
Your choices are:
≈Set the clock
∆Memorize channels
«Add/delete channels
∫πMENU to go back
∂ ππADJUST to select
≤¥≥πENTER to enter
∑ ππADJUST to select