Filter
Top Products
28
Auto speed programming
Use auto speed programming if you want to record as much of the
program as possible in standard play (SP) speed, but you want the
VCR to automatically switch to extended play (EP) if there is not
enough tape left.
Auto speed programming is only available for one program. In the
first slot, the recording speed default is AUTO.
Make sure that the Tape video function matches the length of tape
you are using. See Selecting and adjusting the audio and
video functions on page 23.
At the point where the recording mode changes from standard
play (SP) to extended play (EP), some noise may be in the picture
or sound when playing the tape.
Program caution
If your VCR is set to record, but the power is still ON within 3
minutes before timer recording starts, this screen will appear to
remind you to turn off the VCR.
If the VCR is still turned on 12 seconds before the start time of the
recording, that timer recording will be cancelled.
TV programs that end on the day after
If you want to start the recording at 11:00 PM and end it at 2:00
AM the next day, simply set the start time to 11:00 PM on the
recording start day and the end time to 2:00 AM. There is no need
to change the day of the week.
Program skip using menus
Sometimes you may want to skip one day of a timer recording but
do not want to erase it. Program skip will prevent the recording,
for that day only, of a program you have scheduled to record every
day or every week.
1 Press MENU on the remote control. Your VCR will turn on
and VCR Main Menu will appear. Press the ADJUST
buttons to select Program to record. Press ENTER.
2 Recap screen will display for 4 seconds. While this screen
is displayed, press the ADJUST buttons to place the cursor
arrow next to the program you wish to skip.
3 Press STOP. The cursor arrow will change to a
X
.
4 Press MENU twice to exit the menus.
To resume recording every day or every week, change the
X
to
the cursor arrow by following steps 1 to 4 again.
¬Program to record
CH DAY ON OFF
2 MO10 11:30am 1:30pm SP
10 TH13 9:00pm 10:00pm EP
X 2 M-F 8:00am 8:30am SP
--- -- --:-- --:-- SP
Use STOP to skip on/off
∂ ππADJUST to select
≤¥≥πENTER to enter
∑ ππADJUST to select
REC in 3 min
Turn off VCR
program caution
¬Program to record
CH DAY ON OFF
2 MO10 11:30am 1:30pm SP
10 TH13 9:00pm 10:00pm EP
§ 2 M-F 8:00am 8:30am SP
--- -- --:-- --:-- SP
Use STOP to skip on/off
∂ ππADJUST to select
≤¥≥πENTER to enter
∑ ππADJUST to select
Timer Recording