Mitsubishi Electronics LT-52153 Flat Panel Television User Manual


 
34 3. Using TV Features
Closethecurtains.c.
Setlevelsbyperformingtheprocedureind.
AdjustingLevels.”
Fromthe
1.
Initial > SoundPromenugotothe
Custommenu.
Positionyourselfinyourusualviewinglocation.
2.
Remaininthisposition,lookingattheTV,while
makingthefollowingadjustments.
Adju
3.
sting Beam Angles
a. AdjustCenter Beam Angleuntilsoundis
aboutequalinbothears.
b. AdjustLeft Beam Angletomaximizesound
heardfromthefrontleftside.
c. AdjustRight Beam Angletomaximizesound
heardfromthefrontrightside.
d. AdjustLeft Surround Beam Angletowhere
thesoundseemstocomefromtheleftrear
side.Ifthiscannotbeachieved,makethe
settingthesameasthatforLeftBeamAngle.
e. AdjustRight Surround Beam Angletowhere
thesoundseemstocomefromtherightrear
side.Ifthiscannotbeachieved,makethe
settingthesameasthatforRightBeamAngle.
Adjus
4.
ting Levels
a. AdjustCenter Leveltothemidlevel.
b. Adjustthefollowinglevelsoneatatimesothat
eachonesoundsaboutthesameasthecenter
level:
Left Level
Right Level
Left Surround Level
Right Surround Level
c. Checkallsoundlevelsbyquicklyswitching
betweenthemusing .
d. Readjustindividuallevelsinsmallincrements
andrecheckasaboveuntilallsoundlevels
seemaboutthesame.
Adjusting an External Subwoofer
5.
a. Playsamplevideoormusiccontaininglow-
frequencybasssound.
b. Press
MORE
andthen
9
(AUDIO).Use to
displaytheSubwooferoption.
c. WithSubwoofersettoOn,press
ENTER
to
displayasliderforvolume.
d. Press  toadjustthesubwoofervolume.
How to Make Adjustments in the Custom Menu
Press• toselectanaudiobeam;colorsofthe
adjusterscorrespondtoaudiobeamsintheon-
screendiagram.
Press•  toredirecttheaudiobeamorchange
thesoundlevel.
Controls in the SoundPro
> Custom menu adjust the
direction and focus of the TV’s sound output.
At extreme beam angles, adjustment may be
limited and the image on screen may not accurately
represent the sound beams.
Adjust the volume level of individual audio beams
using sliders in the SoundPro > Custom menu.
Resetting Angle and Level Values in the Custom
Menu
Press
1.
BACK
toclearallmenus.
Press
2.
MENU.
GototheInitial > SoundPromenu
andpress
ENTER
.
Changeanysetting(e.g.,
3.
TV Location).
Press
4.
BACK
toclearallmenus.
Press
5.
MENU.
GototheInitial > SoundPromenu
andpress
ENTER
.
Enterthecorrectvaluesfortheroomlayout.
6.
Returntothe
7.
Custommenutoadjustanglesand
levels.
Sound Projector, continued