Filter
Top Products
22 3. TV Connections
Direct Cable (no cable box)
(can be used with a CableCARD™)
You must connect the incoming cable for your
primary viewing source to
ANT 1/MAIN,
especially for
CableCARD™ use.
1. Connect the primary incoming coaxial lead cable to
ANT 1/MAIN
on the TV back panel.
2. For an optional secondary antenna source, connect
an antenna (or cable) to
ANT 2/AUX
.
3. If you have subscribed to a CableCARD service,
Insert the CableCARD into the CableCARD slot.
#"$,*/1651"/&-
CFMPXMBCFMXJUIJOSFDFTTFEBSFBBUUPQ
"/5."*/
"/5
"69
57#BDL1BOFM
Figure 4. Connection for direct cable service
A. For an antenna with flat twin leads
Required: 300-ohm-to-75-ohm transformer.
A1. For an antenna with flat twin leads, connect the
300-ohm twin leads to the 300-ohm-to-75-ohm
transformer.
A2. Push the 75-ohm side of the transformer onto
ANT
1
on the TV back panel.
B. For cable or antenna with coaxial lead
Connect the coaxial lead directly to
ANT 1
on the
TV back panel.
#"$,*/1651"/&-
CFMPXMBCFMXJUIJOSFDFTTFEBSFBBUUPQ
"/5."*/
0IN
'MBU
5XJO-FBE
0QUJPOBM0INUP0IN
.BUDIJOH5SBOTGPSNFS
0IN
$PBYJBM
$BCMF
#
"
"
57#BDL1BOFM
Figure 6. Connecting a Single Antenna Lead
Antennas with Separate UHF and
VHF Leads
Required: UHF/VHF combiner
1. Connect the UHF and VHF antenna leads to the
UHF/VHF combiner.
2. Push the combiner onto
ANT 1/MAIN
on the TV
back panel.
#"$,*/1651"/&-
CFMPXMBCFMXJUIJOSFDFTTFEBSFBBUUPQ
"/5."*/
#BDL
7JFX
4JEF
7JFX
6)'"OUFOOB
$IBOOFMT
7)'"OUFOOB
$IBOOFMT
0INUP
0IN
$PNCJOFS
'MBU5XJO-FBE
6)'
7)'
5P"/5."*/
57#BDL1BOFM
&YUFSOBM
"OUFOOB
PS$BCMF
Figure 5. Connecting separate UHF and VHF Antennas
Mitsubishi strongly recommends you avoid using
antennas with flat twin leads. Flat twin lead
antenna wires are subject to interference which
may adversely affect the performance of the TV.
We recommend using coaxial antenna cable.
Antenna with a Single Lead