Filter
Top Products
1
1
50
mm
(2")
50
mm
(2") 50
mm
(2")
Wall
Wall
50
mm
(2")
50
mm
(2")
You can attach your optional mount or stand to the plasma display in the following way:
1.Before performing work make sure to disconnect the AC cord from the plasma display.
2.Before performing work spread the protective sheet, which was wrapped around the display, on a flat, even surface. This will
prevent the display from being damaged.
3.Use the handles (Drawing B) to gently lay the plasma display face down on the protective sheet. (See Drawing C).
4.Do not touch or hold the screen face while carrying the display.
5.To complete the installation follow the instructions included with the stand or other mounting hardware.
CAUTION
This device needs to be attached to a stand or other mounting hardware. Be sure to use a stand or
other mounting hardware that is designed specifically for this product.
DO NOT USE THE BOTTOM CARTON AS A TEMPORARY OR PERMANENT STAND. (See Drawing A)
These are fittings for fastening the unit to a wall to prevent
tipping due to external shock when using the stand
(optional). Fasten the safety fittings to the holes in the
back of the monitor using the safety fitting mount screws.
* Safety metal fittings will differ according to the model.
Screw hole
Wall
Table Top
Safety metal fittings
Screw for Safety metal
fittings
Metal chain
(Not supplied)
Screw or Hook etc.
(Not supplied)
To allow heat to disperse, leave space between surrounding
objects as shown on the diagram below when installing.
Drawing C
Drawing A
When installing or carrying, use the
handles attached to the upper back
of the display.
Drawing B