Filter
Top Products
8
5
4
3
2
1
15
14
13
12
11
10
9
8
7
6
MonitorLink and MonitorLink Control
1. Connect a HDMI to HDMI cable from the MONLINK
OUTPUT of a Mitsubishi HD-6000 Receiver/Controller
to the MONLINK input on the plasma display. A HDMI
to HDMI cable and a RS-232C cable are included in
the HD-6000 accessory box.
2. Connect the L (left) and R (right) audio terminals from
the Mitsubishi Receiver/Controller to AUDIO LEFT
and AUDIO RIGHT on a stereo receiver.
3. Connect the MonitorLink Control cable (RS-232C)
from the Mitsubishi Receiver/Controller back panel to
the plasma display side panel.
External HDMI Device with HDCP Connection
HDMI (High Definition Multimedia Interface) is the first
all digital consumer electronics A/V interface that supports
uncompressed video and multi-channel audio in a single
digital interface. You can connect an EIA/CEA-861/861B
compliant consumer electronic device, such as a set top
box or DVD player with a HDMI or DVI output terminal
to the plasma displays HDMI input terminal. If the
external device has a DVI output only, use a DVI to HDMI
adapter cable to connect to the HDMI terminal.
1. Connect a HDMI cable from the HDMI output of the
external HDMI device to the MonitorLink/HDMI input
on the side of the plasma display.
2. Connect the L (left) and R (right) audio terminals from
the external device to AUDIO LEFT and AUDIO
RIGHT on a stereo receiver.
When used as a HDMI/DVI Input, MonitorLink
input is compliant with HDCP and the EIA-861 standards
for standard, extended and high definition video. This input
is not intended for use with personal computers or devices
outputting video signals with computer resolution.
Signal (Analog)
Red
Green or sync-on-green
Blue
No connection
Ground
Red ground
Green ground
Blue ground
No connection
Sync signal ground
No connection
Bi-directional DATA (SDA)
Horizontal sync or Composite sync
Vertical sync
Data clock
Pin No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
8