Mitsubishi Electronics ws-65413 Projection Television User Manual


 
14
15
Figure 3. Connecting the cable box that does not have
audio or video outputs.
Note: See page 5 for Outdoor Antenna Grounding
Cable Box
(Figure 3)
1. Connect the incoming cable to ANT-A on the
TV back panel.
Connect two coaxial cables as follows:
2. One from LOOP-OUT on the TV back panel to IN
on the cable box back panel.
3. One from OUT on the cable box back panel to
ANT-B on the TV back panel.
NOTE: If your cable box has separate audio/video
outputs, please see Composite Video with
Audio or S-Video with Audio, page 16
(Figure 6).
Note: If you have a digital cable box, refer to your
Digital Cable Box owner’s guide for instructions on
optimal connections to this TV.







 



Antenna or Wall Outlet Cable
(Figure 4)
1.
Connect the incoming cable to ANT-A on the TV
back panel.
Connect two coaxial cables as follows:
2. One from LOOP-OUT on the TV back panel to
ANTENNA IN on the VCR back panel.
3. One from VCR back panel ANTENNA OUT to
ANT-B on the TV back panel.
NOTE: If your cable box has separate audio/video
outputs, please see Composite Video with
Audio or S-Video with Audio, page 16
(Figure 6).
Note: The TV back panel and connections shown here are for reference only and may vary by model.






  








Figure 4. Connecting the VCR with antennas or wall
outlet table.
Connecting an Antenna to a Cable Box or VCR
Note: For models WS-, WS- and WS-,
when the Energy Mode is set to Low, the VCR may not
record programs when the TV is off.