Filter
Top Products
38
39
SETUP Menu: NetCommand® IR Input Assignment and Device
Selection Menus (WS-, WS-, WS-)
3. NetCommand IR Input Assignment
Menu
(Figure 19)
After learning all the individual control buttons for
each device, you can change the input that each device
is connected to.
After selecting Continue Setup (press ENTER) on
the NetCommand IR Device Setup menu screen,
the NetCommand IR Input Assignment Menu will
display. You may assign the Device to the TV or AV
Receiver input at this screen. Selecting the correct
inputs allows the TV to correctly switch devices.
An AV Receiver typically has inputs. If all inputs
have been assigned, N/A will appear and that input
cannot be chosen.
After assigning the correct DEVICE and AVREC
inputs, press HOME or MENU on the TV remote to
return to TV viewing.
NOTE: To program the TV’s remote control for
NetCommand, hold the Power button while entering
the code .
Device Selection Menu
(Figure 20)
If your selection was Yes in the NetCommand IR
Device Setup Menu (page ), the device name will
appear in the Device Selection Menu. This menu
displays on-screen when you press DEVICE on the
TV’s remote control.
A button appears next to the highlighted, selected
device name. Press ENTER to use that device.If
audio is through the AV Rec, you will see an icon,
if there is not an icon, the audio is through the TV
speakers.
You may select the device whether or not the
NetCommand IR Setup Menu has been enabled.
Figure 19. NetCommand IR Input Assignment Menu
NOTE: You will need both the television remote and the device’s remote to perform the Learn Menu functions.
Figure 18. VCR Setup Menu
Figure 20. NetCommand IR Device Selection Menu
TV Picture