Mitsubishi Electronics WS-48515 Projection Television User Manual


 
56
57
Setup Menu
Language
Display the on-screen menus in either English or
Spanish (Español). The first time you powered On your
TV, you were requested to select an on-screen menu
language. If you choose to change the selection, all
menu text will immediately switch to the language of
your choice.
Color Balance
Figure 9
Your Mitsubishi TV uses six colors (Magenta, Red,
Yellow, Green, Cyan and Blue) to create color balance.
You may adjust the intensity of the colors automatically,
manually (PerfectColor™) or Reset them to the default
settings. Each TV input or device has a memory for
PerfectColor.
Auto
If the Auto box for Color Balance is checked, your TV
will optimize color automatically and continuously. Both
Manual Color Adjustment and Reset Color options are
grayed out and unavailable when Auto is checked.
PerfectColor™ (Manual Color Correction)
Figure 9
The manual PerfectColor option is only available
when Color Balance Auto is not checked. Select
PerfectColor and press ENTER to display the menu
for manual color adjustment. Individual sliders for
Magenta, Red, Yellow, Green, Cyan and Blue will be
displayed. The sliders have a numeric value, where 63
is the maximum. The default setting for each color is
31 (center). Highlighted text will show which slider you
are adjusting. Each active input can be individually
adjusted.
Figure 8. Setup Menu, Language option
Setup Menu
Figure 8
Figure 9. PerfectColor Menu, Manual Color Correction
Press ADJUST or to navigate between colors and
ADJUST or to change the color slider settings.
Reset
Select to reset the Color Balance settings. The settings
for the device shown in A/V Memory Reset will be
returned to the factory default settings. Each active
input can be individually reset.
Convergence.
Your Mitsubishi TV has three picture tubes which need
to be aligned to properly converge the projected light
beams on the screen. Each picture tube projects a
single color of red, blue or green.
During production, your TV was carefully adjusted to
properly align these colors. However, moving the TV,
the TV’s location in relation to the Earth’s magnetic
poles, and the passage of time can cause these
adjustments to change.
As a special feature, you have the ability to adjust the
red and blue light beams in reference to the fixed green
light beam. This process is called convergence. There
are two separate memories for convergence. One, for
SD 480i/480p signals; the other for HD 1080i signals.
SD convergence should be adjusted while watching an
SD source and HD convergence should be adjusted
while watching an HD source.
The TV should be fully warmed up before adjusting
Convergence. Turn the TV On and wait at least 30
minutes before starting adjustments.