Filter
Top Products
60
61
Antenna Menu
Figure 16
Antenna Menu
The Antenna Menu options are available for use with
analog and digital channels on Antenna-1 and Antenna-
2. You can memorize, add or delete, name and add
channels to an SQV (Super Quick View™) list.
Memorize
For Antenna-1 (Main) or Antenna-2 (Aux)
Select either Air (when used with an indoor/outdoor
antenna) or Cable (when used with direct cable)
then press ENTER to start the automatic channel
memorization process. If a CableCARD is being
used, memorized channels are provided by your cable
provider through the CableCARD.
To stop the automatic channel memorization process,
press CANCEL. Channels memorized before you
pressed CANCEL are retained in memory.
After memorizing channels, the channels in the memory
can be accessed in ascending or descending order or
by pressing CH or .
The memorization will occur twice, as the TV
memorizes analog and digital channels separately.
Prefer Digital
If a memorized channel is shown both as an analog
and digital channel, a check mark in the Prefer Digital
box will show the digital and hide the analog channels,
when using CH. Removing the checkmark will show
both analog and digital choices.
Antenna Menu
Channel
For additional Channel editing, press ADJUST or
to select the channel or press CH or for channels
already in memory. Channels can also be selected
by using the number buttons. To immediately tune
to the listed channel, press ENTER after entering the
number(s).
For digital channels, when the broadcaster has sent a
virtual channel number, the virtual channel number is
shown in the text box and the original digital channel is
shown below on-screen, as a reference. Press SUB on
the remote to enter a separator for digital numbers.
Memory
After the available channels have been memorized with
Memorize, weaker channels can be added. Unwanted
channels can also be deleted. Press CH or on the
remote control to see the channels in memory. Press
ADJUST or to select Added or Deleted for the
channel shown in the Channel number box.
Name
Analog channels shown on Antenna-1 or Antenna-2
can be named (up to four characters). After you enter
a name, it will appear on the TV screen, next to the
channel number.
1. Press ADJUST or to select each letter.
2. Press ENTER to set the letter and move to the
next letter position.
3. Press CANCEL to move back one position.
Digital channels are automatically named if the
broadcaster sends the information.
Figure 16. Antenna Menu