Mitsubishi Electronics WS-65517 Projection Television User Manual


 
86
Appendix G: Diamond Shield™ Removal for Models
WS-55517 and WS-65517
WARNING
Sharp edges! Always wear gloves to
handle, lift, remove and install the
Diamond Shield and molding clips.
Step 2. Diamond Shield removal
For the WS-55517 and WS-65517:
1. Snap open the molding clips on the right and
left side of the screen. The side closest to the
screen opens. Unsnap the top, bottom and middle,
preferably in that order (the clips are fixed to the TV
and are not detachable). Do not force the clips, they
should open easily. Proceed to steps 2-4.
Open
molding
clip
Closed
molding
clip
Clips are shown
lighter for clarity
Opening the
molding clip
2. To remove the Diamond Shield, slide it out of the
channels, starting with the top. Gently bow the
Diamond Shield towards you and push the top out
of the channel, then lift straight up to remove it from
the bottom channel.
4. Re-install the molding clips for a finished look, by
pushing them back into place, starting at a corner.
Do not use force.
To install the Diamond Shield, reverse the process for
your model.
The Diamond Shield for the WS-55517 and WS-65517 comes installed by the factory. If you prefer, it can be removed
using the steps on these pages. The molding clips can only be removed as described, incorrect removal of the
molding clips can damage the Diamond Shield.
Step 1. WS-55517 and WS-65517 Diamond Shield molding clip
removal
For additional assistance, call
(800) 332-2119.
3. Wipe off any dust with a lint-free cloth and store the
shield carefully where it will not be scratched. This
completes the Diamond Shield removal.