Filter
Top Products
Chapter 3. TV Setup 35
Installing the Remote Control
Batteries
1. Remove the remote control’s back cover by gently
pressing in the tab and lifting off the cover.
2. Load the batteries, making sure the polarities (+) and
(-) are correct. For best results, insert the negative (-)
end first.
3. Snap the cover back in place.
2
1
The remote control requires two AA alkaline batteries.
TV Tips
Turning the TV On or Off
To turn the TV on or off, point the remote control at the
front of the TV and press the
POWER
button. Alternatively,
press the
POWER
button on the front panel of the TV.
If You Turn Off the TV by Mistake
1. Press
POWER
again within about 30 seconds, while
the lamp is still hot, to have the TV come back on
immediately.
2. If the
LAMP
indicator starts blinking (about 30
seconds after you shut off power), wait about one
minute for the
LAMP
indicator to stop blinking and
press
POWER
to turn the TV on again.
Controlling Sound Volume
Press
VOL
/ to adjust the sound level.
Changing Channels
To change channels:
• Enter the channel number using the number keys on
the remote control and press
ENTER
. For a two-part
digital channel, such as 3-1, press
3
—
CANCEL
1
to enter
a dash (separator).
• Press
CH
/ to change channels one channel at
a time.
• Press and hold
CH
/ to move quickly through
channels.
• Press
QV
(QuickView) to switch back to the previ-
ously tuned channel.
• Use the FAV (Favorites) feature to set up lists of
favorite channels and tune to them with the
FAV
key.
See “Channel Menu” in chapter 5.
NOTE: Memorize channels to make finding channels
easier.
Care of the Remote Control
• Use only alkaline batteries.
• Be within 20 feet of the equipment.
• Do not press two or more buttons at the same time
unless instructed to do so.
• Do not allow unit to get wet or become heated.
• Avoid dropping on hard surfaces.
• Do not use harsh chemicals to clean. Use only a soft,
lightly moistened cloth.
• Do not mix old and new batteries.
• Do not heat, take apart, or throw batteries into fire.