Mitsubishi Electronics WS-B55 Projection Television User Manual


 
18
19
Connecting an Analog Antenna, Wall Outlet Cable, or Cable
Box, cont’d.
Cable Box
(Figure 3)
1. Connect the incoming cable to ANT-A on the
TV back panel.
Note: Connect two coaxial cables as follows:
2. One from LOOP-OUT on the TV back panel to
IN on the cable box back panel.
3. One from OUT on the cable box back panel to
ANT-B on the TV back panel.
Antenna or Wall Outlet Cable for
Analog Broadcasts.
(Figure 2)
For antennas with twin at lead
1. For antenna with twin at leads, connect the 300-
Ohm twin leads to the transformer.
2. Push the 75-Ohm side of the transformer onto
ANT-A on the TV back panel.
Note: 300-Ohm to 75-Ohm matching transformers
are not provided with the TV. They should be
available at most electronic stores.
For cable or antenna with coaxial lead
3. Connect the incoming cable to ANT-A on the TV
back panel.
Mitsubishi strongly recommends against using
antennas with twin at leads. Twin at lead
antenna wires are subject to interference which
may adversely affect the performance of the TV.
We recommend using coaxial antenna cable.
Figure 2. Connecting antenna or wall outlet cable for
analog broadcasts.
Figure 3. Connecting the cable box.