Filter
Top Products
76
77
Appendix E: Diamond Shield Instructions
Appendix E: Diamond Shield Instructions
Diamond Shield™ Installation
The instructions below will lead you through the
Diamond Shield installation process.
Included in the Diamond Shield package are the
following items:
For model WS-65511 and WS-65611 only.
(1) Diamond Shield™
(2) molding clips
1. Carefully remove the Diamond Shield™ from
its protective packaging. Wipe off any dust with a
lint-free cloth.
2. Begin by inserting the shield, sliding it into the
channels, starting at one side. Gently bow the
Diamond Shield™ toward you and insert the side
of the Diamond Shield™ into side channel then
install the opposite side.
3. Install the top and bottom molding clips
by pressing them into the opening, starting
at a corner. Do not force the clip. The clip
will slide into place. This completes the
Diamond Shield™ installation.
To remove the Diamond Shield™, reverse the
order of the above process.
Diamond Shield™ for the models WS-B55 and
WS-55511 comes installed by the factory.
for Models WS-B55, WS-55511, WS-65511 and WS-65611