Filter
Top Products
15
ENGLISH
FRANÇAISDEUTSCHNEDERLANDSESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
You may operate the L53 DVD Stereo Receiver from its front panel or via the HTR L53 remote control.
Since the remote will be the primary controller for most cases, we will focus on remote-controlled
operations. Be sure also to read the section, “Front Panel”.
ADJUSTING THE VOLUME
Use the HTR L53 remote’s “VOL” buttons to adjust the “master volume” of the L53, raising or lower
all three channels together.
NOTE
• A momentary buttonpress will change the master volume by 1 unit increments; if you hold down
“VOL” buttons the master-volume change will “run-on” until the button is released.
Since recordings vary considerably in overall average level, there is no imperative to listen at any particular
master-volume setting. A setting of 20 may sound “as loud” from one CD or DVD as 10 does from
another.
• If muting has been activated, adjusting master-volume via the HTR L53 remote or the front-panel knob
automatically releases the mute function.
• The L53 will power-up from standby mode at whatever master volume setting was last used; however,
if the prior setting was greater than -10 the L53 will power up to -10. This prevents inadvertently
beginning a session at excessive volume.
MUTING THE SOUND
Use the HTR L53 remote’s “MUTE” button to silence all channels completely. Muting is always available,
regardless of source selection.
NOTE
• Cycling through standby or powering off releases muting; the L53 will return from standby with
muting off if standby was invoked with muting on.
• A changing input releases muting.
• Adjusting the master-volume via the HTR L53 or the front-panel volume knob automatically releases
the mute function.
SELECTING SOURCES
With the HTR L53’s remote’s “AMP” device selected, the remote’s numeric-button section directly selects
the receiver’s internal DVD and tuner “TUNER”, as well as the other inputs, refer to the orange labels
directly above each button.
• When a source other than the internal DVD is selected, the video signal at the monitor output is either
a black background, or the input video if present.
• When you change sources, the VFL will display the new input
When you want to play back DVD videodiscs, turn on the TV and select the L53’s DVD player. When you
want to experience the three dimensional sound-field of DVD videodiscs, VCDs, or audio CDs from the
L53, press the “AUDIO MODE” button on the L53 and select the SRS ON or OFF.
The HTR L53 Device Selector button “DVD” will enable the transport buttons beneath the HTR L53
navigation buttons. The source selector button “INPUT SELECT” on the L53 can also select DVD as well.
If the L53 is in standby mode, the “OPEN/CLOSE” button will also automatically select DVD mode.
Set the playback picture size according to the aspect ratio of the connected TV in the “SETUP/MEMORY”
OSD menus.
USING THE L53
Operation
L53 IM english v3.qxd 7/20/2005 3:04 PM Page 15