NAD L 53 DVD Player User Manual


 
26
ENGLISH FRANÇAIS
DEUTSCH
NEDERLANDS
ESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
EXECUTING MACROS
To execute a macro, press and release “MACRO”; its button illumination lights for 5 seconds. While it
remains lit, press an HTR L53 button to which a macro has previously been stored. The corresponding
macro will run; as each step executes, its “parent” Device Selector’s button flashes lights briefly; when
execution is finished, the “MACRO” button illumination goes out. Pressing any other HTR L53 button
while a macro is executing will abort the macro. Remember that you must hold the HTR L53 so that its
infrared emitter can activate the target components.
NOTE
When a macro executes, a 1 second delay is automatically inserted between its commands. If you
need more than a 1 second delay between particular commands-for example, to permit a component
to power up completely-you can record “empty” steps into the macro by changing Device Selector
“pages” without entering actual command functions.
BUTTON-ILLUMINATION TIMEOUT
The HTR L53’s button-illumination can be set to remain lit for 0-9 seconds. The default value is 5 seconds.
To set the illumination timeout, simultaneously press-and-hold for 3 seconds both the HTR L53’s “DISP”
and the “0-9” button, with the digit corresponding to the desired timeout duration; the Learn LED will
flash twice to confirm the new setting. When set to zero, the illumination will not turn on at all.
NOTE
Button illumination is the biggest drain on the HTR L53’s batteries. A short button-illumination timeout
will extend battery life appreciably; turning it off altogether (set it to 0 seconds) will lengthen it still
further.
FACTORY RESET
The HTR L53 can be reset to its factory state, deleting all learned commands, copied and punched-
through buttons, macros, and other setup information, reverting all buttons to their pre-programmed
library commands. To perform a factory reset simultaneously press-and-hold for 10 seconds the HTR L53’s
“ON” and “RTN” buttons; the Learn LED will start to flash green. Release “ON” and “RTN” before the
second flash is complete; the Learn LED will turn red, indicate the remote has been reset.
NOTE
You must release “ON” and “RTN” before the second flash goes out, otherwise the unit will not reset;
should this occur, repeat the full procedure.
USING THE HTR L53 REMOTE CONTROL
Operation
L53 IM english v3.qxd 7/20/2005 3:06 PM Page 26