Niles Audio DMS4 Home Theater Server User Manual


 
4
PRECAUTIONS
GENERAL PRECAUTIONS
When installing the equipment ensure that:
it is not moved while in operation
the ventilation holes are not covered
air is allowed to circulate freely around the equipment
it is placed on a vibration free surface
it will not be exposed to excessive heat, cold, moisture or
dust
it will not be exposed to direct sunlight
it will not be exposed to electrostatic discharges
it is not installed vertically or tilted
never place heavy objects on the equipment
If a foreign object or water does enter the equipment, contact
your nearest dealer or service center.
It is advisable when leaving the house, or during a thunderstorm,
to disconnect the equipment from the power supply.
WARNINGS
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
Do not remove the cover from the equipment. There are
no user serviceable parts inside, and opening the case will
invalidate your warranty.
Do not move while the product is running. Movement can
result in irrecoverable data loss and damage to the hard disk.
Allow at least 30 seconds after shutdown before moving to
allow the hard disk to spin down.
Do not pull out the plug by pulling on the power cord; grasp
the plug.
Do not insert anything into the equipment through the
ventilation holes.
Do not cover the ventilation holes with any items such as
tablecloths, newspapers, curtains, etc. To avoid overheating
do not position the DMS4 Digital Music Server near or above
heat sources, and ensure that the ventilation holes are not
blocked.
Do not place naked flame sources, such as lighted candles,
on the equipment.
Do not handle the power lead with wet hands.
At least 2.5cm/1” clearance is required on all sides to allow
air to circulate in and around the product.
Do not splash or spill water on the unit. Do not place objects
filled with liquid (such as vases) on the unit.
CD HANDLING PRECAUTIONS
Handle discs carefully so as not to damage or scratch the
front side. Always keep the disc surface clean
To protect the disc avoid placing it in the following
locations:
In direct sunlight or near a source of heat
In a place which is damp or dirty
In a place which could be exposed to rain, such
as near a window
Do not use a disc with a special shape
For best performance when recording from a CD ensure the
temperature never exceeds 35°C/95°F where the DMS4
Digital Music Server is located
DTS ENCODED DISCS PRECAUTION
CAUTION - when playing DTS encoded discs excessive noise will
be heard on the analog output jacks of the DMS4 Digital Music
-
-
-
Server. To avoid possible damage to the system you should ensure
that the correct connections are made to your amplification system for
replaying this type of disc.
POWER CORD PRECAUTIONS
Your DMS4 Digital Music Server complies with the household
power and safety requirements in your area.
IMPORTANT IF USED IN THE UK:
This apparatus is fitted with an approved moulded 13 amp
plug. To change a fuse in this type of plug proceed as follows:
Remove fuse cover and fuse
Fix new fuse which should be a BS1362 5A, A.S.T.A or
BSI approved type
Refit the fuse cover
If the fitted plug is not suitable for your socket outlets, it should be cut
off and an appropriate plug fitted in its place.
If the power plug contains a fuse, this should have a value of
5A. If a plug without a fuse is used, the fuse at the distribution
board should not be greater than 5A.
Note: The severed plug must be destroyed to avoid a possible
shock hazard should it be inserted into a 13A socket elsewhere.
How to connect a plug
The wires in the power lead are colored in accordance with the
following code:
The BLUE wire must be connected to the terminal which is
marked with the letter “N” or colored BLACK
The BROWN wire must be connected to the terminal which
is marked with the letter “L” or colored RED
The GREEN/YELLOW-GREEN wire must be connected
to the terminal which is marked by the letter “E” or by the
safety earth symbol or colored green or green-and-
yellow
Before replacing the plug cover, make certain that the cord grip
is clamped over the sheath of the lead - not simply over the three
wires.
BATTERY PRECAUTION
This product contains a lithium battery. Danger of explosion
if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by Niles. When
disposing of used batteries, please follow the manufacturer’s
recommendations and comply with governmental regulations or
environmental regulations or environmental public instructions
that apply in your country or area.
STANDBY BUTTON
When this button is pressed once, the power turns On and
information will appear on the display. When pressed again,
press the Off action key or the
;
key on the remote control
to switch to Off mode. When the unit is in Off mode the
“Standby” indicator is lit; the apparatus is not disconnected from
the AC power supply in this mode.
COPYRIGHT NOTICE
This equipment must not be used for unauthorized duplication
of CDs or any other works protected by copyright. No license
to infringe copyright is granted by the sale of this equipment.
Recording and playback of some material may require
permission. For further information refer to the following:
Copyright Act 1956
Dramatic and Musical Performers Act 1958
Performers Protection Acts 1963, and 1972
Any subsequent statutory enactments and orders
1.
2.
3.
1.
2.
3.