Filter
Top Products
9
www.nilesaudio.com
REAR VIEW
IR RECEIVER
The IR Receiver connection allows remote control information
to be carried from other devices directly into the DMS4 Digital
Music Server.
CONTROLLER
The Controller port provides serial communication with
supported devices.
USB
Allows the DMS4 Digital Music Server to communicate with
supported USB devices.
ETHERNET
The Ethernet port is used to connect the DMS4 Digital Music
Server to a high speed Internet connection.
VGA
The VGA connector may be used to connect a VGA monitor.
VIDEO OUT
Connect the composite Video Out of the DMS4 Digital Music
Server to the composite input of a suitable PAL/NTSC TV
(depending on the supplied configuration) to display the TV
User Interface. You may also need to switch the TV to the
relevant AUX input to display the picture.
S-VIDEO OUT
Connect the S-VIDEO output of the DMS4 Digital Music Server
to the S-VIDEO input of a suitable PAL/NTSC TV (depending
on the supplied configuration) to display the TV User Interface.
You may also need to switch the TV to the relevant AUX input to
display the picture.
DIGITAL OPTICAL IN
Reserved for future use.
DIGITAL OPTICAL OUT
The digital optical output can be used to transmit high quality
audio to a device with a digital optical input (D/A converter,
A/V amplifier etc.) using an optical fiber cable without first
being converted to analog. Audio sent via this output is the
same as that sent via the Analog Audio Out 1 connector.
DIGITAL OUT - COAXIAL
By connecting this jack to a digital audio component (D/A
converter, A/V amplifier etc.), digital signals from the DMS4
Digital Music Server can be transmitted directly from the system
without first being converted to analog. Audio sent via this
output is the same as that sent via the Analog Audio Out 1
connector.
DIGITAL IN - COAXIAL
Reserved for future use.
ANALOG IN
Analog sources (such as cassette or vinyl LP) may be recorded
onto the hard disk of the DMS4 Digital Music Server using this
connection. (Not yet supported in the current software release).
ANALOG OUT 1,2,3,4
The DMS4 Digital Music Server is a multi-room device allowing
you to listen to different music in up to four different zones all
at the same time (depending on the configuration purchased).
Each analog output should be connected to the input jacks of a
pre-amplifier.
POWER
Connect the supplied power cord to this connector to provide
power to the unit.
Fig. 1-2 DMS4 Rear Panel