Filter
Top Products
－６０－
11. OTHER PROGRAMMING
11.3 Skip (Channel Deletion)
3 New Programming Flow Chart of Skipped Channel
<Example> To the range of 0 to 1200 °C (K) for skipped channel (CH 3)
Operation screen
[Check]
＋
[To be ready for programming]
[Select the channel to be
programmed newly]
[Programming range/printing
range]
Error message appears?
Temporarily stored
Programmi ng other channels?
＋
Stored
The programmed parameters of
[scale], [alarm], [engineering unit] and
[tag] are cleared at the skipped
channels.
1) Select a computing unit in the
[°C/°F computing selection] if the
channels are newly programmed
to temperature range.
2) Program the required [scale] if the
channels are newly programmed
to voltage range.
3) Program [alarm], [engineering unit]
and [tag] if necessary.
You can check the range
programming of other channels.
Press or to change
channels. The skipped channels are
not displayed.
This programming can be started at
any channel. With the example flow
chart, the programming starts from CH
1. As the programmed parameters of
CH 1 are not changed, they are same
as original parameters.
In the example, CH 3 is a channel to
be newly programmed. If CH 3 has
not been programmed as a skip
channel, new range/printing range is
displayed.
Refer to Section 8.2.
Store the [temporarily stored]
parameters into the memory. (A
programming change mark is printed.)
* Fill used digits with spaces.
Channel
Cursor
Channel
YES
∗
NO
YES
NO
Other
p
ro
g
rammin
g
p
arameters
DISP
SET
END
3
UNIT
ENTRY
SHIFT
SET
END
/
%
Storing
Reference 5
Skipped channel check
Reference 1
Starting channel
Reference 2
Channel No. for ne
w
programming
Reference 3
Range/Printing range
programming
Reference 4
SHIF
T
7
RANGE
Ref. 1
Any key other
than
SHIFT
Numeric keys, etc.
Ref. 2
Ref. 3
Ref. 4
Ref. 5