Filter
Top Products
－８９－
13. REMOTE CONTACTS
13.2 Terminal Allocation for Operation
This explanation is only for the remote contacts (option). Press and simultaneously for 3
seconds or more to display the “Terminal Allocation for Operation” programming screen. This allows allocation of
the desired functions to terminal Nos. 1 to 4 (EX 1 to 4).
1 Programming Mode
2 Programming Flow Chart
<Example> To allocate a chart speed of 3 and stop to
terminal Nos. 1/2 and operation record A to terminal No. 3:
Operation screen
[Check]
[To be ready for programming]
[Selecting operation]
[Selecting operation record
printing A]
[Selecting operation]
Temporarily stored
Stored
Press or to change
terminal Nos. Functions allocated can be
checked. The default allocation is as
follows:
Terminal No. 1:
Terminal No. 2:
Printing on/off and 3 chart
speed selection
Terminal No. 3:
Digital data printing
Terminal No. 4:
List printing (List 1)
With
,
and
, the terminal Nos.
are allocated automatically. Therefore,
when one of these functions is selected,
terminal Nos. 2 to 4 are not displayed.
See Section 13.1. 1 .
Press or to change
functions.
Displays Details
①
None
②
Printing on/off and 3
chart speed selection
③
Message printing
(No. 1 and 2)
④
Message printing
(No. 1 to 5)
⑤
Operation printing A
⑥
Operation printing B
⑦
Operation printing C
⑧
Operation printing D
⑨
Digital data printing
⑩
List printing (List 1)
⑪
List printing (List 2)
⑫
List printing (List 3)
⑬
Totalization reset
Terminal No.
Function
Ref. 1
3 sec. or more
（ ＋ ）
Checking other terminal Nos.
Terminal Nos. 2 to 4 are not
displayed.
Types of functions
0
CLEAR
5
DATA I
DISP
0
CLEAR
5
DATA I
SET
END
%
/
/
%
Cursor
Ref. 2
Ref. 3
%
/
＋
SHIFT
SET
END
ENTRY
ENTRY
ENTRY
Cursor
Cursor
Cursor
Reference 1
Reference 2
Reference 3